ACP Technologies|sublimation| dye, printer, blanks| Unisub Vapor Premiere
Dedicated to all your Digital Decorating needs

Contact Us   |   View Cart

Heat Pressing Info


Mouse Pads and Coasters - Fabric


Sizing and printing a transfer on letter sized paper

1) Design a graphic to fit in a 8" x 9.5" rectangle

2) Preheat press to 400°F and set to medium pressure
3) Place a clean sheet of plain paper on the heat press table (optional)
4) Use spray adhesive to secure the transfer to the mouse pad, placemat or coaster and place face-up in heat press
5) Place the mouse pad on the press face up

6) Place a clean sheet of plain paper on top (optional)

7) Press for 45 seconds adjusting time as necessary for best result



The information contained herein is included for illustrative purposes only and, to the best of our knowledge, is accurate and reliable.  ACP Technologies cannot, however, under any circumstances make any guarantee of results or assume any obligation or liability in connection with the use of this information.  As ACP has no control over the use to which others may put its products, it is recommended that the products be tested to determine if suitable for a specific application and/or information is valid in a particular circumstance.  Responsibility remains with owner for the design, application and proper installation of each product.  Specifier and user shall determine suitability of products for a specific application and assume all responsibility in connection therewith.

  Customer Service: 1-800-741-2551

425 Cross St. - Ste 213, Punta Gorda, FL  33950

Mon–Fri 9am-5pm EST
©2018 ACP Technologies. All rights reserved.